Resin Feed
Enka® Resin Feed

Enka® Resin Feed is an infusion channel with a 3D matrix for fast resin flow. The high rate of resin flow increases efficiency and reduces infusion time. Enka® Resin Feed provides steady flow speeds over large surfaces and is available in two widths that can be used up to 150˚C (302°F).
PV-66-50 50 mm x 100 m (1.96″ x 328.08′)
PV-66-100 100 mm x 100 m (3.93″ x 328.08′)
Download PV-66 Enka Resin Feed Technical Data Sheet
Elevated Resin Feed with steel coil

PRO-VAC PV-68 Elevated Resin Feed is a combination product that allows the resin feed to be elevated above the part when under vacuum to prevent part imperfections caused by resin feed lines. It is comprised of a steel coil resin feed and PRO-VAC Standard Flow Infusion Mesh (PV-50). The steel coil is 16 mm (0.629″) in diameter and the infusion mesh allows the spiral to stand 5.1 cm (2″) off the part. The PRO-VAC Elevated Resin Feed can be used up to 120˚C (250°F).
Sold in 40 ft. rolls.
Download PV-68 Elevated Resin Feed Data Sheet
Hoses
Spiral Hose

PRO-VAC Spiral Hose is made out of polyethylene and has a maximum use temperature of 100˚C (212°F). Thickness is 1mm (.038″). It is available in 10 mm (.39″) and 12 mm (.47″) (inner diameter).
PV-61-10 10 mm x 100 m (.39″ x 328.08′)
PV-61-12 12 mm x 100 m (.47″ x 328.08′)
*Available while supplies last
Download PV-63 Distribution Hose Technical Data Sheet
Distribution Hose

PRO-VAC Distribution Hose is made of polyethylene and has a maximum use temperature of 100˚C (212°F). Available in 10 mm (.39″) (inner diameter).
PV-63-10 10 mm x 100 m (.39″ x 328.02′)
*Available while supplies last
Download PV-63 Distribution Hose Technical Data Sheet
Fittings
Infusion Valve

O-ring Infusion Valve
PRO-VAC Infusion Valve is a polyethylene, double O-ring infusion valve. It’s available in 12 mm, and 18 mm (outer diameter) and can be used up to 100˚C (212°F).
PV-70-12 12 mm (.47″)
PV-70-18 18 mm (.70″)
Download PV-70 Infusion Valve Technical Data Sheet
T Connector

PRO-VAC T Connector is a polyethylene connector used in resin infusion, vacuum bagging, and other composite processing applications. This T-shaped connector is available in 12 mm (.47″) (outer diameter) and 18 mm (.7″) and can be used up to 100˚C (212°F).
PV-76-12 12 mm (.47″)
PV-76-18 18 mm (.70″)